Close

March 8, 2017

Milling A TAC 80% Polymer Lower Receiver Pt:1

Awhile ago I did a how-to series on the Tennessee Arms Company 80% Polymer Lower Receiver.  It was rough.  In part because I am not a machinist and being my first time, I stumbled through it.  So, in the interest of making a more streamlined and user friendly video on how to mill out a 80% polymer lower receiver…     ….we have this.

Join me in Part 1 where I go over the tools you will need, tools you will want, and step by step how to complete your project.  We finish it in Part 2 here.

You can find the TAC 80% Lower Receiver Kits here.

Instructions… …you should probably follow them.

2 Comments on “Milling A TAC 80% Polymer Lower Receiver Pt:1

David Bryant
April 1, 2017 at 10:26 pm

I purchased a Donald Trump lower from infowars. It didn’t come with any drill bits or any detailed instructions. I don’t know if it was supposed to or not, but if not were can I get some detailed instructions. I don’t want to mess this up. Thank you.

Reply
jatta
April 1, 2017 at 11:57 pm

Assuming it is a Tennessee Arms Company lower, you should be able to find the stuff you need from them: http://www.tnarmsco.com/ Or just source the bits at a hardware store. As to written instructions, they should have came with the lower, otherwise talk to TAC.

Reply

Leave a Reply

Your email address will not be published. Required fields are marked *